Product no.: 200116
Plug-on module 2-point controller A heater (tubular lamp) is mounted on the Plug-On Module 2-point controller, which is covered with a transparent cover. The temperature is measured with a Pt1000 temperature sensor and an NTC resistor. The power supply and the heating are indicated by a green and red LED. The following practical examples are included in the supplied teachware: Introduction to control technology: 2-point controller, controller without hysteresis; controller with hysteresis; PTC resistor; NTC resistor; LDR resistor; temperature measurement with Pt100 /Pt1000 resistance sensor; Practical applications Propagator with Pt100
Note: The Plug-On Module 2-point controller on the LOGO!Learn Advanced only functions in conjunction with the expansion module Pt100/Pt1000 - with LOGO! AM2 RTD. |
90.00 €
*
In stock |
Product no.: 100119
Training device LOGO!Learn Advanced 8 Programme für LOGO!Soft Comfort
Furthermore, it is possible to use external simulators such as plug-on modules motor, traffic light, cube, etc. (see product data sheet) or models via a 24-pin interface connector. Scope of delivery: 1 Training device LOGO!Learn Advanced with LOGO!8 Translated with www.DeepL.com/Translator |
640.00 €
*
In stock |
|
Product no.: 701209
Training system PLC-Learn 1200 without CPU 1215C The "PLC-Learn 1200" training system is based on a plastic housing. For signal input there are 8 push/latch switches and for analog value output 2 potentiometers for voltage adjustment (e.g. actual/setpoint value) 0-10V/DC 10mA integrated. The signal output and the signal input are each indicated by 8 LEDs (status). The "flash cards" field can be used to place flash cards and test them with the supplied 32 tasks with suggested solutions. The 32 supplied tasks with solutions are structured according to the principle from "easy to difficult" and are very well suited for training as well as for exam preparation, e.g. for the training occupation "power electronics technician specialising in industrial engineering" (CPU 1215C). It is also possible to plug plug-in modules such as motors, traffic lights, cubes, etc. as well as models onto a 24-pin interface connector. At the 26-pin interface, fischertechnik models such as the cycle line with 2 processing machines, conveyor belt etc. can be directly connected. 8 external inputs and 8 external outputs can be fed to the CPU via connecting cables at the spring-loaded terminals attached to the board (10A, up to a nominal cross-section of 1.5qmm). Furthermore, 2 analog inputs and 2 analog outputs of the CPU can be supplied via connecting cables to the CPU. Switching from current output 0..20mA to magnetic output 0...10V is possible via a slide switch. An extension of the mounting rail for the construction of further modules, e.g. LOGO!8, is possible. TECHNICAL DATA: Operating voltage: 24V DC / 750mA 1 PLC-Learn 1200 without SIMATIC 1215C DC/DC/DC, nominal 24V DC Dimensions: 310 x 170 x90mm (LxWxH) Weight: 1 Kg
|
645.00 €
*
In stock |
|